Please Note: We have removed the labels from the pictures in the documentation due to inconsistencies with label orientation. The LED must be aligned above the USB socket when inserting or removing a development board from an expansion board/Pytrack/Pysense/Pyscan.
Store: Buy Here
Getting Started: Click Here
The datasheet of the FiPy is available as a PDF File.
The drawing of the LTE-M antenna is available as a PDF File. LTE-M Antenna Drawing
The pinout of the FiPy is available as a PDF File
Please note that the PIN assignments for UART1 (TX1/RX1), SPI (CLK, MOSI, MISO) and I2C (SDA, SCL) are defaults and can be changed in Software.
By default, upon boot the FiPy will create a WiFi access point with the SSID
XXXX is a random 4-digit number, and the password
The RF switch that selects between the on-board and external antenna is connected to
P12, for this reason using
P12 should be avoided unless WiFi is disabled in your application.
Vin pin on the FiPy can be supplied with a voltage ranging from
3.3v pin on the other hand is output only, and must not be used to feed power into the FiPy, otherwise the on-board regulator will be damaged.
The AT commands for the Sequans Monarch modem on the FiPy are available in a PDF file.
Tutorials on how to the FiPy module can be found in the examples section of this documentation. The following tutorials might be of specific interest for the FiPy: