If powering up normally or upon pressing the reset button, a Pycom module will boot into standard mode; the
boot.py file will be executed first, followed by
main.py. It is possible to alter the boot procedure of the module by tying certain pins
low when the module boots.
If you updated your device before using it, you have already put the device into bootloader mode. This is achieved by connecting
GND while the device boots. If you used a Pysense/Pytrack to update, it did this automatically for you. You only need to put your Pycom module into bootloader mode if you are updating its firmware, or are programming your own low level code. This is not required if you are updating your MicroPython code.
Some times the code you have written will prevent you gaining access to the REPL or prevent you updating your code. Some example may be:
In order to fix this you can safe boot your module. This will prevent
main.py from being executed and will drop you straight into the interactive REPL. After reset, if
P12 pin is held
high (i.e. connect it to the
3V3 output pin), the heartbeat LED will begin flashing orange slowly. If after 3 seconds the pin is still held high, the LED will start blinking faster. In this mode the module will do the same as previously explained but it will also select the previous OTA image to boot if you have updated the module via the OTA update procedure (updates performed via the firmware update tool do not count). This is useful if you flashed a OTA update that breaks the device.
P12 released during:
|1st 3 secs window||2nd 3 secs window|
||Same as previous but using previous OTA firmware|
The selection made during safe boot is not persistent, therefore after the next normal reset, the latest firmware will proceed to run again.
If problems occur within the filesystem or you wish to factory reset your module to remove your code, run following code in the REPL:
>>> import os >>> os.fsformat('/flash')
Be aware, resetting the flash filesystem will delete all files inside the internal device storage (not the SD card) and they cannot be recovered.
Pycom devices support both soft and hard resets. A soft reset clears the state of the MicroPython virtual machine but leaves hardware peripherals unaffected. To do a soft reset, press
Ctrl+D on the REPL or from within a script, run:
>>> import sys >>> sys.exit()
A hard reset is the same as performing a power cycle to the device. In order to hard reset the device, press the
reset switch or run:
>>> import machine >>> machine.reset()