Store: Buy Here
Getting Started Click Here
The pinout of the GPy is available as a PDF File.
Please note that the PIN assignments for UART1 (TX1/RX1), SPI (CLK,MOSI,MISO) and I2C (SDA,SCL) are defaults and can be changed in Software.
The datasheet of the GPy is available as a PDF File.
By default, upon boot the GPy will create a WiFi access point with the
XXXX is a random 4-digit number, and the password
The RF switch that selects between the on-board and external antenna is connected
P12, for this reason using
P12 should be avoided unless WiFi is disabled
in your application.
Vin pin on the GPy can be supplied with a voltage ranging from
3.3v pin on the other hand is output only, and must
not be used to feed power into the GPy, otherwise the on-board regulator
will be damaged.
The AT commands for the Sequans Monarch modem on the GPy are available in a PDF file.
Tutorials on how to the GPy module can be found in the examples section of this documentation. The following tutorials might be of specific interest for the GPy: