LoPy 4

Last updated 24 days ago

Store: Buy Here

Getting Started: Click Here

Datasheet

The datasheet of the LoPy4 is available as a PDF File.

Pinout

The pinout of the LoPy4 is available as a PDF File

Please note that the PIN assignments for UART1 (TX1/RX1), SPI (CLK, MOSI, MISO) and I2C (SDA, SCL) are defaults and can be changed in Software.

Notes

WiFi

By default, upon boot the LoPy4 will create a WiFi access point with the SSID lopy4-wlan-XXXX, where XXXX is a random 4-digit number, and the password www.pycom.io.

The RF switch that selects between the on-board and external antenna is connected to P12, for this reason using P12 should be avoided unless WiFi is disabled in your application.

Power

The Vin pin on the LoPy4 can be supplied with a voltage ranging from 3.5v to 5.5v. The 3.3v pin on the other hand is output only, and must not be used to feed power into the LoPy4, otherwise the on-board regulator will be damaged.

Tutorials

Tutorials on how to the LoPy4 module can be found in the examples section of this documentation. The following tutorials might be of specific interest for the LoPy4: